Programmable Controllers
      Back to home
      1. Help Center
      2. Automation/Electrical
      3. Programmable Controllers

      Are there any cables available to connect the Programmable Controller (PLC) or the Programmable Terminal to a personal computer's USB port?

      Yes. Use the D-sub to USB-serial conversion cable.

      This cable can connect the Programmable Controller "SYSMAC", Programmable Terminal "NT/NS Series", or Programmable Relay "ZEN" to a personal computer's USB port.

      Model Number

      CS1W-CIF31

      Compatible Software Applications

      Software applications using the CX-Server or Fins Gateway to communicate with the Programmable Controller

      The following software applications are also compatible.

      CX-Programmer, CX-Simulator, CX-Protocol, CX-Motion

      CX-Position, CX-Process, DeviceNet Configuration Tool

      DAIKANYAMA 32, NS-Designer, Windows Version of NT Support Tool (NTST)

      *There are Communications (COM) port limitations with the NT Support Tool.

      ZEN Support Software (Ver.3.0 and later)

      The following OMRON Programmable controllers, Programmable Terminals and Programmable Relays which are supported by the compatible software applications

      Programmable Controller

      CS/CJ Series, C Series (C200HS, C200HE/HG/HX, C200H/C1000H/2000H, CQM1, CPM1, CPM1A, CPM2A, SRM1, CQM1H, SPM2C), CVM1/CV Series

      Programmable Terminal

      NS Series, NT Series

      Programmable Relay

      ZEN

      Connector specifications

      Personal Computer side: USB (A plug connector, male)

      Programmable Controller side: RS-232C (D-sub 9-pin, male)

      * "Windows" is a registered trademark of Microsoft Corporation.